During one of the thousands of trips to Home Depot….I kid you not, I kept passing by these in the lumber section. And I became obsessed with finding a way to use them.
I tried hanging them over and over again, using nails and progressing to sticky tabs with no such luck.
I ended up cutting down a piece of this plywood and gluing them with one of my all time favorite adhesives, E-6000.
Grab a nail with a wider head on it and use a drill bit that is close to the same size.
Drill a hole in the top of your plywood, either on the corner or dead center, depending on how you want it to hang.
Using a smaller drill bit, add a smaller hole attached directly above the bigger one previous made.
Run E-6000 around all edges of the copper tops, apply pressure and let dry over night.
Hang and Enjoy!
Be sure and check out my Parade of Homes Series:
DIY Copper Spring Desk Lamp